Technical Information > Which Slip Resistance Testing Method?
Table 3 of Standards Australia Hand Book HB 197, An Introductory Guide to the Slip Resistance of Pedestrian Surface Materials, suggest both ramp or pendulum slip resistance testing classifications, however it shows no bias. It is important to understand that tribometers (slip resistance testing meters) measure the friction of the two interacting surfaces and any solid or liquid medium within the system. Different footwear in combination with different contaminants will provide different slip resistance testing results. As such, there is no direct correlation between these four slip resistance testing methods.
It seems sensible that slip resistance testing methods should be used to simulate the intended conditions for normal usage in terms of the contaminant likely to be present and the footwear intended to be worn. In general terms, the wet pendulum and dry FFT slip resistance testing methods should be used in all situations with additional ramp slip resistance testing in specific specialised situations as tabulated below:
AS 4586 | Testing Method | Contamination | Footwear | Example |
Appendix A | Pendulum | Water | Simulation of Smooth soled shoes | External walkways Entry foyer (wet) Lift lobbies Toilet facilities Shopping centres and shops inside shopping centres |
Appendix B | Dry FFT | | Simulation of Smooth soled shoes | Internal dry areas |
Appendix C | Wet Barefoot | Water | Barefoot | |
Appendix D | Oil Wet | Oil | Profiled safety boots | Commercial kitchens Industria |
For example, it seems nonsensical to specify a surface using the oil wet ramp slip resistance testing method for external walkways and entry foyers, where the most likely contaminant will be water and many people will be wearing shoes that may have a hard soling compound and a worn tread pattern. In this instance the wet pendulum slip resistance testing method is more appropriate.
Oil wet ramp slip resistance testing (R Classification), which uses safety boots with large volumetric tread pattern and high viscosity motor oil, seems to be of little relevance for normal conditions (that the general public will normally encounter). Additionally, the ramp slip resistance testing methods cannot be used in situ, thus these slip resistance testing methods can only be used to evaluate the selection of proposed floor surfaces. If there is a dispute regarding an installed surface or a incident occurs, only pendulum slip resistance testing and dry FFT slip resistance testing methods can confirm the onsite performance.
AS 4663 | Testing Method | Contamination | Footwear | Example |
Appendix A | Pendulum | Water | Simulation of Smooth soled shoes | Entry foyer (wet) |
Appendix B | Dry FFT | Dust, Soil | Simulation of Smooth soled shoes | Internal dry areas |
Appendix C | Ramp Test Methods Cannot Be Used Onsite | |||
Appendix D | Ramp Test Methods Cannot Be Used Onsite | |||
An example of potentially hazardous situation that commonly arises is when an R10 product is specified externally and does not achieve a minimum of pendulum class W as recommended in HB197. This situation is usually discovered during the first few periods of rain on new developments. Although the ramp slip resistance testing indicates that the surface may be suitable, a pendulum slip resistance testing can identify that the product has inadequate slip resistance. Many instances have identified R10 rated products achieving the lowest pendulum classification. Onsite slip resistance testing using the pendulum then confirms the lack of slip resistance, which can also be compounded by any reduction in slip resistance during and after installation.
The information on this webpage was sourced from http://www.safeenvironments.com.au/which-slip-resistance-testing-method/. Safe Environments (www.SafeEnvironments.com.au) have provided Academy Tiles permission to reprint. For further information on slip resistance testing and consulting, please phone Safe Environments on 02 9624 2600; or email info@safeenvironments.com.au.